top of page
ZIRCOFOAM CERAMIC FOAM APPLIED BY CASTING OR INJECTION
ZIRCOFOAM CERAMIC FOAM SPRAY APPLICATION
ZIRCOFOAM Instant Ceramic Foam
Three way for application: Casting, Injection Molding and Spray.
ZircoFoam is an amorphus ceramic foam obtained from bicomponent formulation with a very low organic polymer percentage.
It is hardening and expanding by cemical reaction of the two components in ratio of 10:1.
The best skill of this material is to be a good insulant with high temperature up to 1500°C (standard formulation 1100°C).
It's possible to apply by injection, directry in the place where you needor by injection molding.
ZircoFoam is possible to use also by spray which is possible to apply 1 to 3mm by each layer.In this way is possible to reduce the temperature of the surface above 28 to 30% compare to bare metal.
​
​
​
​
​
​
​
​
​
Instruction about HOW TO USE IT with manual gun
​The advice for using Zircofoam
Depliant ZIRCOFOAM SCHIUMA CERAMICA
Schede tecniche ZIRCOFOAM SCHIUMA CERAMICA
T+39 045 8840041 F+39 045 8840771
INSULANT PUTTY ZIRCOFOAM G600
INSULANT PUTTY ZIRCOFOAM - New!
​STUCCO ISOLANTE ZIRCOFOAM G600 è uno stucco per alta temperatura pronto all'uso.
Scheda tecnica STUCCO ISOLANTE ZIRCOFOAM G600
AGGREGATE ZIRCOFOAM G290
AGGREGATE ZIRCOFOAM - New!
AGGREGATE ZIRFOAM is based on two-component tecnology of silicate with ceramic perticle and mineral granule.
​
Scheda tecnica AGGREGATO ZIRCOFOAM G290
AGGREGATE ZIRCOFOAM G400
Scheda tecnica AGGREGATO ZIRCOFOAM G400
AGGREGATE ZIRCOFOAM G360
Scheda tecnica AGGREGATO ZIRCOFOAM G360
AGGREGATE ZIRCOFOAM G350
Scheda tecnica AGGREGATO ZIRCOFOAM G350
bottom of page